Carry out setting out
This unit of competency specifies the skills and knowledge required to identify perimeter site boundaries and survey indicators to establish, measure and set up profiled set-outs for buildings and structural components of building work, meeting all relevant requirements of the National Construction Code (NCC), Australian Standards, work health and safety (WHS), and Commonwealth and state or territory legislation.
- Check your eligibility
- Check the list of Registered Training Organisations (RTOs) below
- Find a provider located near you
- Contact the provider directly using the contact details listed
Eligibility for funding
It is important to note that only eligible participants may receive funding for eligible courses. Select a course to view the funding program options, eligibility criteria and find a Registered Training Organisation in your location.
Participant Eligibility
An eligible participant for this program
MUST BE:
- an Australian or New Zealand Citizen or Permanent Resident or
- a participant who has the right to work and study in Australia on a VISA and has been employed in the Building and Construction Industry for a period of 6 months or more and is
- an eligible worker in Queensland or is
- an unemployed eligible worker who has been unemployed for a period not greater than 6 months, in Queensland.
MUST NOT BE:
- an employee of an Authority
- currently enrolled and participating in a Queensland secondary school program,
- a contracted trainer or assessor or existing worker of an RTO,
- funded by an Authority or such other source for delivery of the same training being undertaken as part of this program,
- funded for more than eight (8) short courses under this program (either in building specific and/or civil specific) in the same program period,
- funded for more than three (3) high risk work (HRW) units of competency (excluding Asbestos units of competency) in the same program period,
- a participant seeking a verification of competency.
Training providers
There are no results. Try selecting a different region.